coating thickness

The effect of zinc coating thickness to the quality of spot welding of zinc-coated steel

镀层厚度对镀锌钢板点焊质量的影响

Books and periodicals on the cohesion and effectiveness of resin content, gummed coating thickness and grooving.

书刊的黏结效果与上胶量 、 背胶的涂布厚度及开槽大小有关.

Coating Thickness Distribution of an Arc and its Simulation Based on The New Model of Spray Gun

基于喷炬新模型的圆弧面涂层厚度分布及仿真研究

Some poor quality aluminum plates to hide version based on the photoptic rubber coating thickness.

有些劣质版材为了包藏铝版底基上的砂纲,不兵感平胶膜层的厚度增不小.

The valuable conclusions are followed here based on the experimental study and comprehensive analysis.1.In the full array test, taking the coating thickness as indicator, we analyze the steel, processing temperature and processing time on coating thickness.

通过以上分析研究，得到以下结论：1.在全排列试验中，主要以覆层厚度为考察指标，分析钢种、处理温度与处理时间对覆层厚度的影响。

The mathematics model that showed photoresist spin coating thickness evolvement on spherical surface was put forward.

提出了球面旋涂微米级厚度光刻胶膜层薄化率公式及径向位置演变公式,并得到了膜厚分布的演变公式.

Results show that thermal fatigue behavior is associated with circle temperature and coating thickness.

结果表明,复合涂层的热疲劳行为与热循环上限温度、涂层厚度有关.

A Coating Thickness Measurement System Based on Fringing Electric Field Sensor

基于边缘电场传感器的涂层厚度检测系统

Performance and Application of Coating Thickness Gauge by Magnetic Method and Eddy Current Method

磁性法和电涡流法测厚仪的特点及其应用

Study on the Influence of Coating Thickness, Mould Structure Type and Rotational Speed on Outside Surface Quality of Centrifugal Casting Ductile Iron Pipes by Heated Mould Method

铸型类型及其转速和涂料层厚度对热型法离心铸造球铁管外表面质量影响的试验研究

On the viscosity on coating thickness has a great impact, on a low viscosity, overlay thin.

上光油的黏度对涂层厚度有着较大的影响, 上光油的黏度低, 涂布层薄.

The results show that in the initial stage of micro-arc oxidation the obtained ceramic coating is compact and nearly no microflaw can be observed, the microflaws like holes begin to appear in the exterior and finally irregular holes fill with 90% of the thickness range.

结果表明：微弧氧化初期，陶瓷层致密，几乎观察不到显微缺陷，随着处理时间的延长及陶瓷层的增厚，其外侧开始出现孔洞类缺陷，直至90%厚度范围布满相互交错的不规则孔洞；

A Superficial Comment on Coating Thickness of Threaded Fasteners and Screw Thread Fit Clearance in Aircraft Applications

浅谈飞机螺纹连接件电镀层厚度及螺纹配合间隙

Coating thickness measurement control depends on the speed of the gap and roller.

涂层厚度的控制就取决于计量辊的间隙和辊筒的转速等因素.

The preparations before test shall include corrosion check, mechanical inspection, vehicle photo, coating thickness measurement, metal thickness identification, paint layer scratch and etc.

试验前的准备工作包括腐蚀检查、机械检查、车辆拍照、涂层厚度测量、金属厚度识别及油漆层划线等。

Establish the better thickness range of film coating;

确定薄膜衣层的最佳厚度范围；

Spraying equipment along with roller axial movement speed determines the roller surface coating thickness.

喷涂装置沿辊筒轴向移动的速度决定了辊筒表面获得的涂布厚度.

Some factors including pipe length, free span length, outside diameter of the pipe, wall thickness of the pipe, concrete coating thickness, and seabed slope were studied in the sensitivity analysis.

同时进一步分析了模型计算长度、悬跨长度、管道外径、钢管壁厚、混凝土配重层厚度以及海床坡度等因素对海底悬跨管道多点输入非线性反应的影响。

To replace the expensive β ray thickness meter the coating thickness is controlled by using photoelectric transducer.

介绍采用光电传感器代替昂贵的β射线测厚仪，实现涂层厚度控制；

The thickness of the coating has slight effect on friction-reducing properties but remarkable effect on anti-wear performance, there is an optimum coating thickness to improve anti-wear performance.

涂层厚度对涂层的减摩性能影响较小，但对其抗磨性能影响较大，并存在提高抗磨性能的最佳涂层厚度。

The influence of the coating thickness on the waveform is analyzed.

该方法为透明薄膜/基底系统的定量检测和无损评价提供了理论依据.

The back of the coating thickness according to need.

不面后涂层的厚度可根据需给.

The results showed that increasing the rotational speed of mould is an effective means to reduce or eliminate the defects of pit and that coating thickness is an important factor influencing outside surface quality of casting pipes.

研究结果表明，提高铸型转速是减少乃至消除铸管表面凹陷的有效手段；涂料层厚度是影响铸管外表面质量的重要因素。

Evolvement model of photoresist spin coating thickness on spherical surface

球面旋涂光刻胶膜厚分布的数学模型